Sony MDCC-2000 Operating Instructions - Page 34

Transcribing (continued) If you use the foot control unit, you can use the auto backspace function. This function enables you to confirm the last few words each time you resume playback by re-starting playback from just before the point where you stopped. Using the Auto Backspace function 1 2, 3, 4 Note Even if the reverse time is set, the recorder might not backward by the set amount in the following cases because there is no time to save onto the memory. - When you insert a disc and first start playback. - When you playback after fast-forward or backward. - When you playback after a search operation. - When you playback immediately after REC. - Immediately after exchanging decks. What is the Auto Backspace Function? When you start playback, the unit stores recorded data in the memory (maximum of about 10 seconds) and plays it back. If you set the reverse time, you can stop playback by releasing the pedal once and then step on the pedal again (Listen) to backward by the set time in the memory and start playback again. The reverse time is factory-set to 0 seconds. You can set it within the range about 0 to 10 seconds. Example 1: The reverse time is set to 0.0 1Playback 2Release the pedel of the foot control unit here. approx.10 sec in memory recorded contents 3Next playback will start from this point. 4Playback Example 2: The reverse time is set to 5.0 1Playback 2Release the pedel of the foot control unit here. approx.10 sec in memory recorded contents 3Next playback will start from this point. 4Playback 34 Advanced Operations