Sony MDCC-2000 Operating Instructions - Page 40

Alarm System An alarm sounds and an indication appears on the display window in the following situations. Alarm system When pressing the zREC button m A continuous beep sounds while the zREC button is pressed. During recording m Long, intermittent beeps continue to sound. During recording or copying m Short, intermittent beeps continue to sound. During recording, when recording finishes or when copying finishes m Three short beeps sound. During pause m Two short beeps sound every 10 seconds. Situation • The disc cannot be recorded onto. Recording deck: There is no disc. Alternatively, the disc inserted is protected, commercially available pre-recorded disc or has too small a capacity. Continuous deck: The disc inserted is not blank. • The disc has nearly reached the end, but there is no recording enabled disc in the continuous deck. • There is something wrong with the disc, but there is no recording enabled disc in the continuous deck. • Recording or copying was interrupted due to some error. • The disc was recorded to the end of the disc and was automatically ejected. • Recording was interrupted by an error and the disc was automatically ejected. • Copying ended and the disc was automatically ejected. • Currently pausing. Note If you press the zREC or xSTOP button of either deck during pause, the beeps will continue to sound once just after the unit has been paused but will stop repeating every 10 seconds. This alarm stop function will be cleared when you stop recording later. To release alarm system • Insert a disc that can be recorded into the recording deck. • Insert a blank disc into the continuous deck, or remove any disc from the continuous deck. • Insert a blank disc into the continuous deck immediately. Note Press zREC or xSTOP button to stop the alarm sound. • Insert a blank disc into the continuous deck immediately. • Replace the disc and try to record or copy again. Note Press zREC or xSTOP button to stop the alarm sound. • Replace the disc and try to record again. • Replace the continuous disc with a blank disc for the next continuous recording. 40 Additional Information