Sony PEG-UX40 CLIE Handbook - Page 80
Setting the Network preferences for a wireless LAN for PEG-UX50 only
View all Sony PEG-UX40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
Setting the Network preferences for a wireless LAN (for PEG-UX50 only) 2 Power Save: The Power Save function is enabled by default. If the communication reception of the wireless LAN is low, cancel the Power Save function, and communicate with the maximum power. In this case, the battery of your CLIÉ handheld is quickly exhausted. Enable Power Save function in normal use. To cancel the Power Save function, tap next to [Power Save:] to change to . 3 IP address: DHCP (Dynamic Host Configuration Protocol) is enabled by default. When DHCP is cancelled, the IP Address screen is displayed and you can manually set up an IP Address, Netmask(Subnet mask), Router(Gateway), Primary DNS, and Secondary DNS. To cancel DHCP, tap next to [IP address:] to change to . 4 Auto Connect: If this item is enabled, when your CLIÉ handheld is connected to a wireless LAN access point automatically (refer to P.82), this setup is treated as one for selection. Auto Connect is enabled by default. To cancel Auto Connect, tap next to [Auto Connect:] to change to . 10 Tap [OK]. The SSID Setup screen is closed, and the Wireless LAN Setup screen which added the new SSID setting under [SSID:] is displayed. 11 Tap [OK]. The Wireless LAN Setup screen is closed, and the Preferences screen is displayed. Customizing your CLIÉ™ handheld (Preferences) 80