Sony TDM-NC1 Operating Instructions (Large File - 10.48 MB) - Page 35
Messages, If the unit still does not operate, properly after performing the, above measures - problems
UPC - 027242710900
View all Sony TDM-NC1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
• Make sure not to place the unit too far from the wireless LAN router. • Check your wireless LAN connection environment. You cannot use CH 12 and 13 (for European customers). • If the electric wave is crossed with other wireless LAN waves, change the wireless channel. • Check for obstacles (metallic wall, etc.) installed between the wireless access point and the unit. These obstacles shorten the wave's reach length. • When using the PARTY MODE, using IEEE802.11g (wireless)/100BASE-TX (wired) for LAN connection is suggested. If the unit still does not operate properly after performing the above measures, reset the unit as follows: While the unit is 'on' (the unit is connected to an AV system), press RESET on the bottom of the unit using a fine-tipped tool (e.g. pencil, etc.). The unit is reset to the factory settings. You should set the settings you made. Messages If a message appears while using the unit, follow the procedures below to correct the problem. Network Cannot Play • Start up M-crew Server Ver. 2.5 and click [ERROR LOG] in the LAUNCHER window, or right-click the M-crew Server task tray icon* and select "ERROR LOG VIEWER", then check the error log. • The track cannot be played in the following cases: - Sampling rate is other than 32 kHz, 44.1 kHz, 48 kHz. - The track is not being streamed by linear PCM. - The track is other than one channel or two channel. - The track sampling bits are other than 16 bits. - The server status is busy. Check Net • Check that the network cable between the unit and the hub or router is firmly connected. • Check that the hub or router is turned on. • Set the wireless LAN router channel to any channel from CH1 to CH11. For details, refer to the operation manual of your wireless LAN router. • The wireless signal is not strong enough. Move the unit closer to the wireless access point. If the unit is already close to the access point, check the configuration of the access point to ensure that the access point is sending a signal. Once the changes have been made to the access point, toggle the WIRELESS/WIRED selector to reconfigure setting. IP Conflict • Set the IP addresses of the unit and other devices on the network so that there is no duplication (page 32). No Item • Register the track as instructed by the operation manual of the connected server. • Follow the procedure below and reconnect to the server. 1. Press MENU. 2. Select "SERVER?" in the network menu (page 31), then press ENTER. 3. Press ./> repeatedly to select the desired media server, then press ENTER. 35GB