TP-Link T1600G-18TS Jetstream Smart Switches User Guide - Page 222

Configuring GVRP GVRP Configuration Step 9 Step 10 end Return to privileged EXEC mode. copy running-config startup-config Save the settings in the configuration file. Note: •• The member port of an LAG follows the configuration of the LAG and not its own. The configurations of the port can take effect only after it leaves the LAG. •• The egress rule of the ports dynamically added to the VLAN is tagged. •• The egress rule of the fixed port should be tagged. •• When setting the timer values, make sure that the values are within the required range. The configuration value for LeaveAll timer should be greater than or equal to ten times the Leave timer value. The value for Leave timer should be greater than or equal to two times the Join timer value. The following example shows how to enable GVRP globally and on port 1/0/1, configure the GVRP registration mode as fixed and keep the values of timers as default: Switch#configure Switch(config)#gvrp Switch(config)#interface gigabitEthernet 1/0/1 Switch(config-if)#gvrp Switch(config-if)#gvrp registration fixed Switch(config-if)#show gvrp global GVRP Global Status Enabled Switch(config-if)# show gvrp interface gigabitEthernet 1/0/1 Port Status Reg-Mode LeaveAll JoinIn Leave LAG ---- Gi1/0/1 Enabled Fixed 1000 20 60 N/A Switch(config-if)#end Switch#copy running-config startup-config User Guide 197