TP-Link T1600G-18TS Jetstream Smart Switches User Guide - Page 444

Configuring Routing IPv4 Static Routing Configuration 2.2 Using the CLI Follow these steps to create an IPv4 static route. Step 1 configure Enter global configuration mode. Step 2 ip route { dest-address } { mask } { next-hop-address } [ distance ] Add an IPv4 static route. dest-address: Specify the destination IPv4 address of the packets. mask: Specify the subnet mask of the destination IPv4 address. next-hop-address: Specify the IPv4 gateway address to which the packet should be sent next. distance: Specify the administrative distance, which is a rating of the trustworthiness of the routing information. A higher value means a lower trust rating. When more than one routing protocols have routes to the same destination, only the route that has the shortest distance will be recorded in the IP routing table. The valid values are from 1 to 255 and the default value is 1. Step 3 show ip route [ static | connected ] Verify the IPv4 route entries of the specified type. Step 4 end Return to privileged EXEC mode. Step 5 copy running-config startup-config Save the settings in the configuration file. The following example shows how to create an IPv4 static route with the destination IP address as 192.168.2.0, the subnet mask as 255.255.255.0 and the next-hop address as 192.168.0.2: Switch#configure Switch(config)#ip route 192.168.2.0 255.255.255.0 192.168.0.2 Switch(config)#show ip route Codes: C - connected, S - static * - candidate default C 192.168.0.0/24 is directly connected, Vlan1 S 192.168.2.0/24 [1/0] via 192.168.0.2, Vlan1 Switch(config)#end Switch#copy running-config startup-config User Guide 419