TP-Link T1600G-18TS Jetstream Smart Switches User Guide - Page 493

Configuring DHCP Service Configuration Examples 5.1.4 Using the CLI 1) Enable DHCP Server. Switch#configure Switch(config)#service dhcp server 2) Specify the Pool Name, Network Address, Subnet Mask and Lease Time. Switch(config)#ip dhcp server pool pool Switch(dhcp-config)#network 192.168.0.0 255.255.255.0 Switch(dhcp-config)#lease 120 Switch(dhcp-config)#exit 3) Bind the specified IP address to the MAC address of the FTP server. Switch(config)# ip dhcp server pool pool Switch(dhcp-config)# address 192.168.0.8 hardware-address FC-AA-14-59-E9-4A hardware-type ethernet Switch(dhcp-config)#end Switch#copy running-config startup-config Verify the Configuration Switch#show ip dhcp server binding IP Address Client id/Hardware Address Type Lease Time Left --------- 192.168.0.2 01-d43d-7ebf-615f Automatic 01:57:27 192.168.0.8 01-fcaa-1459-e94a Manual Infinite 5.2 Example for DHCP Interface Relay 5.2.1 Network Requirements The administrator deploys one DHCP server on the network, and wants the server to assign IP addresses to the computers in the Marketing department and the R&D department. It is required that computers in the same department should be on the same subnet, while computers in different departments should be on different subnets. After adding the DHCP server, the network topology will be as shown in Figure 5-5. The Marketing department and the R&D department belong to VLAN 10 and VLAN 20, respectively. The IP address of VLAN interface 10 is 192.168.2.1/24, and the IP address of VLAN interface 20 is 192.168.3.1/24. The DHCP server is connected to the routed port of User Guide 468