TP-Link T1600G-18TS Jetstream Smart Switches User Guide - Page 250

Configuring Layer 2 Multicast IGMP Snooping Configuration Last Member Query Count: 3 General Query Source IP: 192.168.0.5 ... Switch(config)#end Switch#copy running-config startup-config 2.2.3 Configuring IGMP Snooping for Ports Follow these steps to configure IGMP Snooping for ports: Step 1 Step 2 configure Enter global configuration mode. interface {fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range gigabitEthernet port-list | ten-gigabitEthernet port | range ten-gigabitEthernet port-list| port-channel port-channel-id | range port-channel port-channel-list} Enter interface configuration mode. Step 3 ip igmp snooping Enable IGMP Snooping for the port. By default, it is enabled. Step 4 Step 5 ip igmp snooping immediate-leave (Optional) Enable Fast Leave on the specified port. Fast Leave can be enabled on a per-port basis or per-VLAN basis. When enabled on a per-port basis, the switch will remove the port from the corresponding multicast group of all VLANs before forwarding the leave message to the querier. You should only use Fast Leave for a port when there is a single receiver connected to the port. For more details about Fast Leave, see 2.2.2 Configuring IGMP Snooping for VLANs. show ip igmp snooping interface [fastEthernet [ port-list ] | gigabitEthernet [ port-list ] | tengigabitEthernet [ port-list ] | port-channel [port-channel-list] ] basic-config Show the basic IGMP Snooping configuration on the specified port(s) or of all the ports. Step 6 end Return to privileged EXEC mode. Step 7 copy running-config startup-config Save the settings in the configuration file. The following example shows how to enable IGMP Snooping and fast leave for port 1/0/13: Switch#configure Switch(config)#interface range gigabitEhternet 1/0/1-3 Switch(config-if-range)#ip igmp snooping User Guide 225