TP-Link T1600G-28PS T1600G-28PSUN V3 CLI Reference Guide Guide - Page 118

T1600G-28TS(config-if)# switchport pvid 2 13.5 switchport check ingress Description The switchport check ingress command is used to enable the Ingress Checking function for the switch ports. With this function enabled, the port will accept the packet of which the VLAN ID is in the port's VLAN list and discard others. With this function disabled, the port will forward the packet directly. To disable this function, please use no switchport check ingress command. Syntax switchport check ingress no switchport check ingress Command Mode Interface Configuration Mode (interface gigabitEthernet / interface range gigabitEthernet / interface port-channel / interface range port-channel) Privilege Requirement Only Admin, Operator and Power User level users have access to these commands. Example Enable Ingress Checking on the port 1/0/2: T1600G-28TS(config)# interface gigabitEthernet 1/0/2 T1600G-28TS(config-if)# switchport check ingress 13.6 switchport acceptable frame Description The switchport acceptable frame command is used to specify the acceptable frame type for the switch ports and the ports will perform this operation before Ingress Checking. To restore to the default setting, please use no switchport acceptable frame command. Syntax switchport acceptable frame { all | tagged } 97