TP-Link T1600G-28PS T1600G-28PSUN V3 CLI Reference Guide Guide - Page 154

Privilege Requirement Only Admin and Operator level users have access to these commands. Example Enable unknown multicast filter function: T1600G-28TS(config)# ipv6 mld snooping drop-unknown 18.3 ipv6 mld snooping vlan-config Description The ipv6 mld snooping vlan-config command is used to enable VLAN MLD Snooping function or to modify MLD Snooping parameters. To disable the VLAN MLD Snooping function, please use no ipv6 mld snooping vlan-config command. Syntax ipv6 mld snooping vlan-config vlan-id-list [ rtime router-time | mtime member-time | ltime leave-time ] no ipv6 mld snooping vlan-config vlan-id-list [ rtime | mtime | ltime ] Parameter vlan-id-list -- The ID list of the VLAN desired to modify configuration, ranging from 1 to 4094, in the format of 1-3, 5. router-time -- The Router Port Aging Time. Within this time, if the switch does not receive any MLD query messages from the router port, it will consider this port is not a router port any more. Valid values are from 60 to 600 in seconds, and the default value is 300 seconds. member-time -- The Member Port Aging Time. Within this time, if the switch does not receive any MLD report messages from the member port, it will consider this port is not a member port any more. Valid values are from 60 to 600 in seconds, and the default value is 260 seconds. leave-time -- The Leave Time. Valid values are from 1 to 30 in seconds, and the default value is 1 second. When the switch receives a done message from a port to leave a multicast group, it will wait for a Leave Time before removing the port from the multicast group. During the period, if the switch receives any report messages from the port, the port will not be removed from the multicast group. Exceptions are as follows: • If the member port ages out before the Leave Time ends and no report messages are received, the port will be removed from the multicast group once its Member Port Aging Time ends. 133