Toshiba R600 S4202 Maintenance Manual - Page 271
Installing the USB board/WL holder
UPC - 883974167104
View all Toshiba R600 S4202 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 271 highlights
4.17 USB board/WL holder 4 Replacement Procedures Installing the USB board/WL holder To install the USB board/WL holder, follow the steps below and refer to Figure 4-23 and 424. 1. Set the WL holder in place and fix it with the double-sided tape. CAUTION: A double-sided tape is stuck to a new WL holder. Wipe off the double-sided tape stuck on the cover assembly. 2. Set the USB board and secure it with the following screw. • M2×3B S-THIN HEAD ×1 CAUTION: When installing the USB board, align the switch knob of the USB board to the slot of the WL holder. 3. Connect the camera harness to the connector CN9540 on the USB board. 4. Connect the sensor harness to the connector CN9620 on the USB board and connector CN9630on the SW board and close the insulator (HNS HOLD INSULATOR). 5. Connect the USB board FPC to the connector CN9610 on the USB board. CAUTION: When arranging the cables, be careful of the following: Do not put the cables indicated in the circle. 6. Set the RJ45 wire harness into the slot. 7. Arrange the RJ45 wire harness and fix it with the insulator. PORTÉGÉ R600 Maintenance Manual (960-709) [CONFIDENTIAL] 4-43