Toshiba R600 S4202 Maintenance Manual - Page 84
Procedure 2, Message Check
UPC - 883974167104
View all Toshiba R600 S4202 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
2 Troubleshooting Procedures 2.6 HDD/SSD Troubleshooting Procedure 2 Message Check When the power is turned on, the system performs the Initial Reliability Test (IRT) installed in the BIOS ROM. When the test detects an error, an error message is displayed on the screen. Make sure no floppy disk is in the FDD. Turn on the computer and check the message on the screen. When an OS starts from the 2.5" HDD, go to Procedure 3. Otherwise, start with Check 1 below and perform the other checks as instructed. Check 1 If any of the following messages appear, go to Procedure 3. If the following messages do not appear, perform Check 2. HDC ERROR or HDD #X ERROR (After 5 seconds this message will disappear.) Check 2 If either of the following messages appears, go to Check 3. If the following messages do not appear, perform Check 4. Insert system disk in drive Press any key when ready ..... or Non-System disk or disk error Replace and press any key when ready Check 3 Using the SYS command of the DOS, transfer the system to the 2.5" HDD. If the system is not transferred, go to Procedure 3. Refer to the DOS Manual for detailed operation. If the following message appears on the display, the system program has been transferred to the HDD. System Transferred If an error message appears on the display, perform Check 4. Check 4 2.5" HDD(s) and the connector(s) of system board may be defective (Refer to the steps described in Chapter 4, Replacement Procedures for disassembling.). Insert HDD(s) to the connector(s) firmly. If it is (or they are) firmly connected, go to Procedure 3. 2-38 [CONFIDENTIAL] PORTEGE R600 Maintenance Manual (960-709)