Tripp Lite BP48V Eaton Tripp Lite SmartOnline Series Tower UPS Advanced User G - Page 44
Table 11. UPS Alarm Codes Continued, Alarm Code, Displayed Alarm, Potential Cause, Action
View all Tripp Lite BP48V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Typical Alarms and Faults Table 11. UPS Alarm Codes (Continued) Alarm Code Displayed Alarm 110 BUILDING ALARM 200 BP PHASE NOT OK 206 BP FREQ. NOT OK 208 BP OVERLOAD 209 BP VOLT NOT OK 603 BATTERY MODE 604 BATTERY LOW 60D NO BATTERY 612 BAT TEST ABORTED 700 CURRENT LIMIT 706 UPS TEMP. ALARM 802 IMMINENT SHUTOFF 806 EMERGENCY OFF 80E OVLD PREALARM 810 POWER OVERLOAD Potential Cause Action building alarm by input signal contactor Phase out of range (bypass input and inverter output cannot phase lock) Check Bypass AC frequency Frequency out of range Check Bypass AC frequency Bypass overload alarm Check and reduce load Input Voltage out of bypass range Please check input voltage Battery is discharging Please check input voltage Battery level is below RemainingCapacityLimit threshold or RunTimetoEmpty is below RemainingTimeLimit threshold. Please check the mains and Prepare to shut off load Battery not present Please check if batteries are connected rightly or fuse is open Check: UPS mode is AC (online) or HE; Load must be greater than 10%; Battery capacity should be >=80%; Battery test condition is not met. There is no running alarm (excepted Battery fault); Load level has not varied by more than +/- 10 percent (from the initial load level present at the beginning of the test to the beginning of step2 test). inverter current limitation Check load UPS internal temperature is high Please check ambient temperature and if the ventilation is blocked, and if fan works normal. shut down imminent for battery low Please prepare for shutdown emergency stop was proceed Please check if RPO is active output power above threshold 102%(default), settable from HMI. Check overload pre-alarm setting and load Output power overload, Max (P,S) > L2 (L2 = 102%) Please check the load capacity 38 Tripp Lite by Eaton SmartOnline Series User Guide 614-21326-Rev 01