Viking DTWN3648SS Installation Instructions - Page 21

6 5/16" nut driver CAUTION: Secure vent hood to wall using screws provided. Use additional mounting screws and wall anchors, if necessary. 7 BARE OR GREEN WHITE WHITE GREEN BLACK BLACK 5/16" nut driver CAUTION: If not using a duct cover, using screws provided make sure top mounting screws are secured into soffit or cabinet frame. Use additional mounting screws, if necessary. 8 1 1 2 Connect black to black, white to white, and the green/bare wire under the green screw. NOTE: Housing wiring must be properly installed for wiring to be correct when wiring unit. 9 1 Replace electrical box cover. Make connection to breaker box. 10 1 2 3 Slide filter front over front lip. Push filter rear up, then slide back over rear lip. 3 2 Slide spacer front over front lip. Push spacer rear up, then slide back over rear lip. 40 11 1 3 2 Slide filter front over front lip. Push filter rear up, then slide back over rear lip. Duct Cover Option (DCH 12"H. Classic Chimney Wall Hoods w/Standard Ventilator) 1 2 Measure distance from ceiling to canopy. 3 Tape to avoid scratching. 4 2 Place duct cover top inside duct cover base and lower until desired height is found. Mark height. Use the retaining nuts and bolts to fasten in place from the inside and remove tape. Slide duct cover in place and fasten from inside canopy using the sheet metal screws provided. 41