Weider Xr20 English Manual - Page 14

29. Press a 1 1/2Ó Square Inner Cap (32) into the 29 Seat Frame (36). Insert the 1/4Ó x 2Ó Carriage Bolt (38) into the center hole in the Seat Plate (37). Attach the Seat Plate to the Seat (13) with two 1/4Ó x 3/4Ó Screws (18). Insert the 1/4Ó x 2Ó Carriage Bolt (38) into the indicated hole in the Seat Frame (36). Tighten a 1/4Ó Nylon Locknut (2) with a 1/4Ó Flat Washer (10) onto the Carriage Bolt. Attach the other end of the Seat (13) to the Seat Frame (36) with a 1/4Ó Flat Washer (10) and a 1/4Ó x 2Ó Screw (24). 30 30. Lubricate the 5/16Ó x 2 1/4Ó Bolt (33). Attach the Leg Lever (29) to the Seat Frame (36) with the Bolt and a 5/16Ó Nylon Locknut (3). 13 38 37 18 36 32 24 10 2 36 33 3 Lubricate 29 SEAT ASSEMBLY 31. Attach the Short Cable (35) to one of the 31 three holes in the Leg Lever (29) with a 5/16Ó x 3/4Ó Bolt (73), a 5/16Ó Washer (8), and a 5/16Ó Nylon Locknut (3). Note: The three holes are for cable adjustment. Insert the Short Cable between the welded rod and the Leg Lever. Press a 1Ó Round Inner Cap (49) into each end of the Curl Bar (77). Insert a Cable Clip (53) through the upper hole in the Curl Bar and through the Short Cable (35). Insert a 5/16Ó x 1 1/4Ó Carriage Bolt (72) through the lower hole in the Curl Bar. Tighten a 5/16Ó Jam Nut (85) onto the Carriage Bolt. 32. Rest the Seat Frame (36) on the indicated pin on the Front Upright (42). Attach the Seat Frame to the Front Upright with a 5/16Ó x 32 2 3/4Ó Carriage Bolt (14) and the Seat Knob (40). 29 73 8 3 Welded Rod 35 49 53 85 49 77 72 40 36 14 Pin 42 14