Weider Xr20 English Manual - Page 9
Cable Assembly
View all Weider Xr20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
CABLE ASSEMBLY 11. During steps 11 through 27, refer to the CABLE DIAGRAM on page 21 of this manual to verify proper cable routing. Before beginning this section, identify the Long Cable (23), the Medium Cable (58), and the Short Cable (35) by comparing the lengths and ends of the cables. IMPORTANT: While assembling the cables, do not overtighten the bolts and nuts attaching the pulleys. The pulleys must be able to turn freely. 11 23 58 35 12. Locate the Long Cable (23). Route the Long 12 Cable around a 3 1/2Ó Pulley (15). 67 55 23 Using a 3/8Ó x 3 1/2Ó Bolt (16) and a 3/8Ó Nylon Jam Nut (67), attach the 3 1/2Ó Pulley (15) to the Top Frame (55). Be sure that the end of the Cable with the ball is on the indicated side of the Pulley and that the Cable is between the Pulley and the hook on the Top Frame. Ball 15 Hook 16 13. Wrap the Long Cable (23) around a ÒVÓ-Pulley 13 (6). Attach the ÒVÓ-Pulley and a Long Cable Trap (50) to the indicated bracket on the Front Upright (42) with a 3/8Ó x 2 1/2Ó Bolt (7) and a 3/8Ó Nylon Locknut (21). Be sure that the Long Cable Trap is positioned to hold the Cable in place. 14. Route the Long Cable (23) around a ÒVÓPulley (6). Using a 3/8Ó x 2 1/2Ó Bolt (7) and a 14 3/8Ó Nylon Locknut (21), attach the ÒVÓ-Pulley (6) and a Long Cable Trap (50) to the Left Arm (47). Be sure that the Cable is in the groove of the Pulley and that the Long Cable Trap (50) is positioned to hold the Cable in place. 7 6 50 42 23 21 7 6 50 21 23 47 9