Whirlpool WDT730PAHV Installation Guide - Page 23
Option C: Waste disposer - with air gap, Option B: No waste disposer, no air gap
View all Whirlpool WDT730PAHV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Option B: No waste disposer - no air gap Waste tee Large drain hose clamp Drain hose 1 Rubber end 2 Drain trap 1. Fit rubber end of drain hose to waste tee and cut if needed. NOTE: Do not cut ribbed section. 2. Attach rubber end of drain hose to waste tee with a large drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 11/2" to 2" (38 mm to 50 mm) screw-type clamp (not provided). Option C: Waste disposer - with air gap Screw-type clamps Disposer inlet Air gap Large drain hose clamp Rubber hose connector Drain hose Drain trap Helpful Tip: Remove disposer knockout plug. 1 1. Using a hammer and screwdriver, knock plug into disposer. 2 2. Use needle-nose pliers to remove plug. 3 Rubber end 4 5 3. Connect rubber end of drain hose to air gap and cut if needed. NOTE: Do not cut ribbed section. 4. Attach drain hose to air gap with large drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 11/2" to 2" (38 mm to 50 mm) screwtype clamp (not provided). 5. Use a rubber hose (not provided) with screw-type clamps (not provided) to connect from air gap to disposer inlet. 23