Xerox 4260X Quick Use Guide - Page 16

Install Print Drivers This procedure describes how to install Print Drivers using the Print Driver CD. NOTE: If you wish to install different print drivers or are using a different operating system refer to the System Administration CD for full details. The Print Drivers are on the Drivers CD that was delivered with your machine. You can use the Drivers CD to install multiple components such as printer drivers, user documentation and PPDs (PostScript® Printer Descriptions) at the same time. To use the installer, load the Drivers CD-ROM delivered with your machine. 1 At the client workstation insert the Driver CD into the CD drive. 2 If the CD does not start automatically, go to the Start menu, click Run and browse to the CD drive. Click Setup and click OK. Click OK to start the installation procedure. 3 Select the language for the installation and click Continue. The driver screen is displayed. NOTE: The selections are: Install Print and Scan Drivers - Installs both the print drivers and the scan drivers. Install Print Driver - Installs just the print drivers. Install Scan Driver - Installs just the scan drivers. To install Print Drivers use the instructions below. 4 Click Install Drivers. 5 Click Install Print Drivers. NOTE: The PCL6 Driver is installed by default. 6 To install the PCL 5 or PS Print Drivers, click Option and check the boxes for the drivers required. 7 Enter the Printer's IP address, DNS name or UNC path for the device. 8 Click Install. 9 Follow the on screen messages to complete the installation. 10 When the Print Driver is successfully installed, either send a test print from the print driver or submit a job to the WorkCentre 4250/4260 Series printer. 11 If the printing operation is successful, continue on to the next setup procedure in this document. If the print operation failed, refer to Troubleshooting on page 33. For a full explanation refer to the System Administration CD that accompanied your machine. 12 quick use guide