Yamaha AW2816 Owner's Manual - Page 88

Chapter Input/output patching 4 Quickly assigning input signals to tracks (Quick Rec) Quick Rec is a function that lets you quickly switch the patching so that the desired input signal can be recorded on the desired track, while you view the routing in a special screen. By using this function, you can quickly record each instrument on its own track without changing the INPUT jack connections. 1 Press the [QUICK REC] key. The QUICK REC screen will appear. This screen displays the following information. 1 2 3 In the MIX. CH area, move the cursor to the input channel jack for the desired patch source, and press the [ENTER] key. The selected input channel will be highlighted. In the following illustration, input channel 7 has been selected. 1 MIX. CH This area shows the type of input signals that are assigned to input channels 1-8 (CH 1-CH 8). The (jack) symbols displayed at the right of the box indicate the direct output of each input channel. B REC. TR This area shows tracks 1-16 (TR 1-TR 16) of the recorder section. The (jack) symbols displayed at the left of the box indicate the inputs of each track (recorder inputs 1-16). 2 If you want to change the input signal of a patch source input channel, move the cursor to the numerical box of that channel, and turn the [DATA/JOG] dial. Tip! If you move the cursor to the jack of a highlighted input channel and press the [ENTER] key once again, the selection will be cancelled. 4 Move the cursor to a jack symbol in the REC. TR area, then move the cursor to the recorder input (1-16) for the desired patch destination, and press the [ENTER] key. A patch cable will connect the patch source direct output to the patch destination recorder input. Tip! • Steps 3 and 4 can be performed in the opposite order. • The direct output of a channel can be patched to multiple recorder inputs. However, it is not possible to patch multiple direct outputs to one recorder input. 80 Operation section