Yamaha CLP-280 Owner's Manual - Page 109
CLP-280/270: Keyboard Stand Assembly
View all Yamaha CLP-280 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
CLP-280/270: Keyboard Stand Assembly CAUTION • Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor- dance with the sequence given below. • Assembly should be carried out by at least two persons. • Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage. • Be sure to tighten up all screws upon completing assembly of each unit. • To disassemble, reverse the assembly sequence given below. Have a Phillips-head (+) screwdriver ready. Remove all parts from the box. Confirm that all parts shown in the illustration are provided. 6 x 25mm long screws x 4 Headphone hanger A Connector panel AC INLET Styrofoam pads Take out the styrofoam pads, and place A on top of the pads. Position the styrofoam pads to protect the connector panel at the bottom of A and the AC INLET. B 6 x 16mm short screws x 6 4 x 14mm thin screws x 8 4 x 20mm tapping screws x 5 Side panel protection (cardboard) pads x 2 C Pedal cord D E F 4 x 10mm thin screws x 2 Cord holders x 2 AC power cord (The shape of plug differs depending on locale.) 1. Attach E and F to D. 1-2 1-1 Secure D using the four 6 x 25mm long screws. 1-2 Remove the twist tie from the folded pedal cord. Do not remove the twist tie located next to the hole. Don't discard the twist tie, you'll need it later in step 6. Appendix 1-1 CLP-280/270 Owner's Manual 109