Yamaha CLP-280 Owner's Manual - Page 76

Detailed settings for the voices [VOICE SETTING] Detailed Settings TIP In Dual mode, parameters with the "*" mark are set for Voice 1 and Voice 2 individually. TIP Parameter names enclosed in parentheses ( ) are displayed in Dual mode. Setting the octave [Octave]* The pitch of a note can be shifted upward or downward in steps of an octave. See the procedure on page 69. A Main Octave Set?--> 0 B NO YES C In Dual mode: A MainxLayer Set?--> Octave(GrndPno1) 0 D B NO YES C D Voice for editing (Voice 1 or Voice 2) Setting range: -2 (two octaves lower) - 0 (no pitch shift) - +2 (two octaves higher) Setting the volume level [Volume]* You can set the volume level for each voice part. See the procedure on page 69. A Main Volume Set?--> 100 C In Dual mode: A MainxLayer Set?--> Volume(GrndPno1) 100 C B NO YES D B NO YES D Voice for editing (Voice 1 or Voice 2) Setting range: 0 - 127 Setting the position of right and left channels [Pan]* You can specify the position in the stereo image from which you hear the sound. See the procedure on page 69. A Main Pan Set?--> C B NO YES C D In Dual mode: A B MainxLayer Set?--> Pan(GrndPno1) C NO YES C D Voice for editing (Voice 1 or Voice 2) Setting range: L64 (hard left) - C (center) - R63 (hard right) Make fine adjustments to the pitch (only in Dual mode) [Detune] The pitch of the two sounds selected in Dual mode can be "skewed" slightly away from each other. See the procedure on page 69. A B MainxLayer Detune Set?--> + 3 NO YES C D Setting range: -20 - +20 (Positive (+) settings will raise the pitch of the first sound and lower the pitch of the second sound. Negative (-) settings will do the opposite.) 76 CLP-280/270 Owner's Manual