Yamaha EMX62M Owner's Manual - Page 11
Front & Rear Panels, Control Panel, n Channel - speakers
View all Yamaha EMX62M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Front & Rear Panels 9 Front & Rear Panels Control Panel s Channel Section The channel controls are used to set the EQ, MONITOR and EFFECT send levels, channel LEVEL, and PAD for each channel. 1 2 3 4 5 1 HIGH & LOW EQ controls The 2-band equalizer allows you to boost or cut the low or high frequency range for each channel. The frequency response is flat when the controls are in the center (w) position. Rotating clockwise boosts frequencies, rotating counterclockwise cuts them. The center frequencies are as follows: HIGH: 10 kHz ±15 dB shelving type LOW: 100 Hz ±15 dB shelving type B MONITOR control The MONITOR control determines the level of the input signal that is fed to the MONITOR bus and subsequently the MONITOR OUTPUT jack (input/output panel 0). The MONITOR control is not affected by the channel's LEVEL control 4, since the MONITOR signal is sourced before that control. C EFFECT control The EFFECT control determines the level of the input signal that is fed to the EFFECT bus and subsequently the onboard effects processor and EFFECT OUT jack (input/output panel 4). EFFECT bus signals are fed simultaneously to the onboard effects processor and the EFFECT OUT jack for use with external effects processors. The EFFECT bus signals are affected by the channel's LEVEL control 4, since the EFFECT signal is sourced after the EFFECT control. To send a channel signal to the EFFECT bus, both the EFFECT and LEVEL controls must be turned up. D LEVEL control The LEVEL control determines the level of the input signal that is fed to the MAIN bus and internal power amplifier. The MAIN bus signal is routed to the MAIN OUTPUT jack (input/output panel 9), SPEAKERS 1 and 2 jacks (rear panel 1), and PHONES jack (input/output panel A). E PAD switch (1-4 only) The PAD switch attenuates the input signal by 30 dB. When connecting a line-level source to inputs 1 through 4, or if a microphone signal is distorted, use the PAD switch to attenuate the input signal. EMX62M-Owner's Manual