Yamaha EMX62M Owner's Manual - Page 14
Input/Output Panel, INPUT TO MAIN jack
View all Yamaha EMX62M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
12 Front & Rear Panels Input/Output Panel 4 A 1 23 1 Hi-Z, Low-Z (inputs 1-4) These are the input connectors for input channels 1 through 4. Both the Hi-Z and Low-Z input can be used with microphones and, by using the PAD switch (control panel 5), can also be used with line-level sources, such as synthesizers and drum machines. Switchable +15 V phantom power is available to the Low-Z XLR-type input for use with condenser-type microphones. Both the Hi-Z and Low-Z inputs are balanced. Pin connections are as follows. Low-Z (XLR-type) Hi-Z (TRS phone jack) Pin 1: ground Pin 2: hot (+) Pin 3: cold (-) Sleeve: ground Ring: cold (-) Tip: hot (+) S RT + - GND GND - + Note: The Low-Z and Hi-Z input of each channel cannot be used simultaneously. Use the input appropriate for the source. Since phantom power is turned on and off for inputs channels 1 through 4 simultaneously, input devices that do not require it should be connected to the Hi-Z input when phantom power is used. B LINE 1 & 2 (input 5) These two phone jacks are the input connectors for input channel 5. They are unbalanced, can be used simultaneously, and are appropriate for use with line-level sources, such as synthesizers and drum machines. 5 6 78 9 0 C Super Hi-Z 1 & 2 (input 6) These two phone jacks are the input connectors for input channel 6. They are unbalanced, can be used simultaneously, and their high input impedance makes them ideal for use with instruments such as electric-acoustic guitar and electric bass. They can also be used with line-level sources, such as synthesizers and drum machines. D EFFECT OUT jack The EFFECT OUT phone jack outputs the signal from the EFFECT bus and can be connected to the input of an external effects processor. E FOOT SW jack The FOOT SW jack is used to connect an optional footswitch, such as the Yamaha FC5, which can be used to turn the built-in digital effects processor on and off. The DIGITAL EFFECT ON switch must be in the ON position in order to use the footswitch. F AUX IN-INPUT TO MAIN jack The AUX IN-INPUT TO MAIN phone jack is used to feed signals from an external source to the MAIN bus and can be connected to the output of an external effects processor, for example. G 2TR IN-INPUT TO MAIN jacks The 2TR IN-INPUT TO MAIN phono jacks are used to feed signals from an external source to the MAIN bus and can be connected to the stereo outputs of a cassette, DAT, or MD deck. H REC OUT-OUTPUT jacks The REC OUT-OUTPUT phono jacks output the MAIN bus signal prior to the 7-band graphic equalizer and MASTER level control, and can be connected to the stereo inputs of a cassette, DAT, or MD deck for recording. EMX62M-Owner's Manual