Yamaha EMX62M Owner's Manual - Page 8

6 EMX62M Quick Guide EMX62M Quick Guide The following steps (1-5) explain the basic connection and operation of the EMX62M. Also, please read "Front and Rear Panel" and "Basic Operation" following this Quick Guide section to learn more about using the EMX62M. STEP 1 Connection Connecting speakers Using speaker cables, connect each speaker to the SPEAKERS 1 and 2 jack on the rear panel of the EMX62M. Connecting a microphone Make sure that the power is turned off to the EMX62M. Connect a microphone to the Low-Z jack of channel 1-4. EMX62M Microphone Using a condenser microphone Turn on the PHANTOM switch (located in the upper right corner on the panel). EMX62M EMX62M • The EMX62M is a monaural mixer. The same signal will be output from all SPEAKERS jacks on the rear panel. You do not need to differentiate right from left speakers. • You may connect to either of the two jacks on the speakers. • Be sure to use a cable designed for speaker connection. Never connect the speakers in the manner shown below. Otherwise, the EMX62M's built-in power amplifier will be damaged. PHANTOM switch • Do not connect or disconnect a condenser microphone while the power to the unit is on and the PHANTOM switch has been turned on. Connecting a CD player, MD player, and/or cassette deck Connect a CD player or MD player to the 2TR IN jacks. Refer to the operation manual of the corresponding device for more information on the input and output of the device. EMX62M EMX62M EMX62M-Owner's Manual CD player Recorder (Cassette, DAT, MD)