Yamaha EMX62M Owner's Manual - Page 16

14 Front & Rear Panels Rear Panel 2 1 SPEAKERS 1 & 2 jacks The SPEAKER 1 & 2 phone jacks output the main signal from the internal power amplifier and are used to connect speakers. They are internally connected in parallel and output the same signal. Connecting one speaker Connecting two speakers 1 Installation The EMX62M uses a forced cooling system with intake on the bottom of the rear panel and exhaust on the top of the rear panel to avoid blocking the heated air flow. NO Front 4Ω-8Ω 8Ω-16Ω 8Ω-16Ω NO 15cm or less Note: The total impedance of the connected speaker system must be between 4 and 8 ohms. This means that you can connect one speaker Exhaust system with an impedance of between 4 and 8 Front ohms to one SPEAKER jack, or two speaker sys- Intake tems each with an impedance of between 8 and 16 ohms to each SPEAKER jack. Do not connect anything other than speakers to these jacks. B AC IN socket Connect the included power cord to this socket. Connect the plug of the power cord to an AC outlet that meets the requirements stated in the specifications in this document. EMX62M-Owner's Manual