Yamaha EMX62M Owner's Manual - Page 12

10 Front & Rear Panels s DIGITAL EFFECT Section The DIGITAL EFFECT section is used to turn the built-in digital effects processor on and off and select effects programs. 6 s MAIN Section The MAIN section is used to set the MAIN MASTER level, 7-band graphic equalizer, AUX IN and 2TR IN levels, and MAIN EFFECT RTN level. It also contains the LIMITER indicator and main output level meter. 8 D C 7 F VOCAL REVERB, LARGE HALL, SMALL HALL switches These switches are used to select the effects programs: VOCAL REVERB, LARGE HALL, SMALL HALL. G DIGITAL EFFECT ON switch & indicator The DIGITAL EFFECT ON switch is used to turn the built-in digital effects processor on and off. The indicator lights up when the processor is on. When the processor is on, its output is fed to the MAIN and MONITOR buses via the MAIN EFFECT RTN 9 and MONITOR EFFECT RTN E controls respectively. The effects processor can also be turned on and off remotely by connecting an optional footswitch to the FOOT SW jack. 9 0 A B H Graphic equalizer The 7-band graphic equalizer is used to boost or cut certain frequencies of the MAIN output signal by up to ±12 dB. It affects the MAIN OUTPUT signal, the speaker outputs, and the PHONES. I EFFECT RTN control The MAIN EFFECT RTN control determines the level of the signal from the built-in digital effects processor that is fed to the MAIN bus and subsequently the MAIN outputs. J AUX IN control The AUX IN control determines the level of the AUX IN signal that is fed to the MAIN bus and subsequently the MAIN outputs. K 2TR IN control The 2TR IN control determines the level of the 2TR IN signal that is fed to the MAIN bus and subsequently the MAIN output. L MASTER control The MAIN MASTER control determines the output level of the MAIN OUT, speaker outputs, and PHONES. EMX62M-Owner's Manual