Yamaha MT2X Owner's Manual - Page 20

Drum Recording Procedure - tape speed

Get Yamaha MT2X PDF manuals and user guides View all Yamaha MT2X manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

- Drum Recording Procedure - 1. Connections Plug the AC cord into an AC outlet. Plug the Digital Rhythm Programmer's stereo outputs into INPUTs 1 and 2. Plug a pair of monitor headphones (rated 8-40 ohms) into the PHONES jack. When using an effect, connect it between the AUX SEND jack (input) and either of the AUX RTN jacks (output). 2. Getting ready Lift open the cassette door and insert a chrome position (CrO2) tape. Bias: HIGH, Eq: 70µs. Return all the switches and controls to their normal positions, referring to the control panel illustration on pages 4~10. Turn the power switches on for the effect and rhythm programmer, and then turn the MT2X "ON". The POWER indicator will light. 3. Setting up the recorder section Press the RESET switch to return the counter to "000". Turn "ON" the ZERO STOP switch. Turn "ON" the dbx switch. Select the appropriate tape speed the 9.5 cm/sec. is recommended. Set the RECORD SELECT switch 1 to the "L" posi- tion. This is to record the Left stereo signal onto track 1. The REC indicator will begin flashing. Press the pause switch to start the recording. The REC indicator will light up completely. 18

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
— Drum Recording Procedure —
1. Connections
Plug the AC cord into an AC outlet.
Plug the Digital Rhythm Programmer’s stereo out-
puts into INPUTs 1 and 2.
Plug a pair of monitor headphones (rated 8–40
ohms) into the PHONES jack.
When using an effect, connect it between the AUX
SEND jack (input) and either of the AUX RTN jacks
(output).
2. Getting ready
Lift open the cassette door and insert a chrome
position (CrO
2
) tape.
Bias: HIGH, Eq: 70μs.
Return all the switches and controls to their nor-
mal positions, referring to the control panel illustra-
tion on pages 4~10.
Turn the power switches on for the effect and
rhythm programmer, and then turn the MT2X "ON".
The POWER indicator will light.
3. Setting up the recorder section
Press the RESET switch to return the counter to
"000".
Turn "ON" the ZERO STOP switch.
Turn "ON" the dbx switch.
Select the appropriate tape speed the 9.5 cm/sec.
is recommended.
Set the RECORD SELECT switch 1 to the "L" posi-
tion. This is to record the Left stereo signal onto
track 1. The REC indicator will begin flashing.
Press the pause switch to start the recording. The
REC indicator will light up completely.
18