2006 BMW 6 Series Owner's Manual - Page 108
2006 BMW 6 Series Manual
Page 108 highlights
The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter. You can operate the system when the engine is running or when the ignition is switched on. If the device can not be used after repeated programming, check whether the original hand-held transmitter uses an alternating-code system. To do so, either read the instructions for the original hand-held transmitter or hold down the programmed memory button 1 of the integrated universal remote control. If the LED 2 on the integrated universal remote control flashes rapidly for a short time and then remains lit for approx. 2 seconds, this indicates that the original hand-held transmitter uses an alternating-code system. In the case of an alternating-code system, program the memory buttons 1 as described at Alternating-code transmitters.< The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter. Deleting stored programs Press both outer buttons 1 for approx. 20 seconds, maintaining pressure until the LED 2 starts to flash: all stored programs are deleted. Programs cannot be deleted individually. Glove compartment Opening Driving tips 107 Reference Mobility Communications Entertainment Navigation Alternating-code hand-held transmitters To program the integrated universal remote control, consult the operating instructions for the equipment to be set. You will find information there on the possibilities for synchronization. When programming hand-held transmitters that employ an alternating code, please observe the following supplementary instructions: Programming will be easier with the aid of a second person.< 1. Park your vehicle within the range of the remote-controlled equipment. 2. Program the integrated universal remote control as described above in Fixed-code hand-held transmitters. 3. Locate the button on the receiver of the device to be set, e.g. on the drive unit. 4. Press the button on the receiver of the equipment to be set. After step 4, you have approx. 30 seconds for step 5. 5. Press the programmed memory button 1 of the integrated universal remote control three times. Press the button. The glove compartment opens automatically and the lamps come on. Closing Fold the cover up. To prevent injury in the event of an accident while the vehicle is being driven, close the glove compartment immediately after use.< Rechargeable flashlight* The flashlight is located on the left side of the glove compartment. The flashlight can remain there continuously. Online Edition for Part-No. 01 41 0 159 709 © 09/05 BMW AG Controls At a glance