2006 BMW 6 Series Owner's Manual - Page 199
2006 BMW 6 Series Manual
Page 199 highlights
Replacing components High beams, parking lamps Front turn signal, sidemarker Your BMW is equipped with two turn signal lamps per side in the front. Turn signal lamp 1 Bulb 21 watts, WY 21 SV The illustration shows the front right side of the engine compartment. 1. Press the lever shown: The illustration shows the front left side of the engine compartment. > downward for the right turn signal > upward for the left turn signal High beams Bulb 55 watts, H 7 1. Remove the cover cap 1 by pressing the tab and removing the cover cap upward. 2. Press the bulb holder from above to release it. 3. Remove the bulb holder. 4. Remove and replace the bulb. The lamp H7 is pressurized; wear eye protection and protective gloves. Otherwise, there is the risk of bodily injury if the lamp is damaged.< 2. Remove the bulb holder towards the rear. 3. Remove and replace the bulb. Turn signal lamp 2 Bulb 21 watts, WY 21 SV The bulb for the turn signal lamp 2 can be replaced via the wheel well. The illustration shows the front left side of the vehicle. 1. Turn the steering all the way to be able to remove the cover, refer to illustration. 2. Turn off the light, switch off the ignition and remove the remote control from the ignition lock. 3. Unscrew the two bolts using the open-end wrench from the onboard tool kit, refer to page 197. Parking lamps Bulb 10 watts Bulb holder and reflector are one unit and are replaced together.< 1. Turn the bulb holder 2 to the right and remove. 2. Press the snap connection on the plug connector, pull off the bulb holder and replace. 198 Online Edition for Part-No. 01 41 0 159 709 © 09/05 BMW AG