2012 Chevrolet Traverse Owner's Manual - Page 277
2012 Chevrolet Traverse Manual
Page 277 highlights
Driving and Operating If the system fails to turn on or activate, one of the following messages will be displayed on the Driver Information Center (DIC): SERVICE TRACTION CONTROL, SERVICE STABILITRAK, the StabiliTrak light will come on and stay and four chimes are heard. If these conditions are observed, turn the vehicle off, wait 15 seconds, and then turn it back on again to reset the system. If any of these messages still appear on the Driver Information Center (DIC), the vehicle should be taken in for service. For more information on the DIC messages, see Ride Control System Messages on page 5‑36. The system may be heard or felt while it is working; this is normal. 9-29 brake-traction control when traction control is off, but will not be able to use the engine speed management system. See "Traction Control Operation" following for more information. When the traction control system has been turned off, system noises may be heard and felt as a result of the brake-traction control working. It is recommended to leave the system on for normal driving conditions, but it may be necessary to turn the system off if the vehicle is stuck in sand, mud, ice, or snow, and you want to "rock" the vehicle to attempt to free it. It may also be necessary to turn off the system when driving in extreme off-road conditions where high wheel spin is required. See If the Vehicle Is Stuck on page 9‑9. The traction control button is located on the instrument panel. The traction control part of StabiliTrak can be turned off by pressing and releasing the traction control button. Traction control can be turned on by pressing and releasing the traction control button and the appropriate TRACTION CONTROL ON message will be displayed, if not automatically shut off for any other reason. When the traction control system is turned off, the appropriate TRACTION CONTROL OFF message will be displayed on the DIC. The vehicle will still have The StabiliTrak light will flash on the instrument panel cluster when the system is both on and activated.