2012 Chevrolet Traverse Owner's Manual - Page 53

Keys, Doors, and Windows Express-Up/Express-Down Windows A window with the express‐up/down feature allows it to be raised or lowered without holding the switch. Press or pull the window switch fully and release it to activate the express feature. The express mode can be canceled by pressing or pulling the switch. Uplevel Shown, Base Similar The power window controls are located on each of the side doors. The driver door also has switches that control the passenger and rear windows. The power windows work with the ignition in ACC/ ACCESSORY, ON/RUN or when Retained Accessory Power (RAP) is active. See Retained Accessory Power (RAP) on page 9‑19. Press the switch to lower the window. Pull up on the front edge of the switch to raise the window. 2-21 2. Press and continue to hold the window switch until the window is fully open. 3. Pull up and hold the window switch to close the window. Continue to hold it briefly after the window is fully closed. 4. Repeat for each window that has the express-up feature. Programming the Power Windows If the battery on the vehicle has been recharged, disconnected, or replaced, windows with the express-up feature need to be reprogrammed for this feature to work. To program the window: 1. Close all doors with the ignition in the ACC/ACCESSORY, ON/ RUN position, or when Retained Accessory Power (RAP) is active. See Retained Accessory Power (RAP) on page 9‑19. Anti-Pinch Feature The anti-pinch feature is on windows with the express-up feature. If an object is in the way of the window as it is express-closing, or in certain weather conditions like severe icing, the window will stop and open to a factory preset position. The window functions normally once the obstruction is removed.