2012 Chevrolet Traverse Owner's Manual - Page 64

3-8 Seats and Restraints position again. If the exit position is still not recalling, see your dealer for service. See "Easy Exit Seat" under Vehicle Personalization (With DIC Buttons) on page 5‑40 for more information. Easy Exit Driver Seat This feature can move the seat rearward to allow extra room to exit the vehicle. WARNING (Continued) overheat. An overheated seat heater may cause a burn or may damage the seat. S (Easy Exit Driver Seat): Press to recall the easy exit seat position. The vehicle must be in P (Park). If the easy exit seat feature is programmed on in the vehicle personalization menu, automatic seat movement occurs when the ignition key is removed. A single beep sounds. The driver seat moves back approximately 8 cm (3 in). To move the seat back farther, press the easy exit seat button again until the seat is all the way back. If something has blocked the driver seat while recalling the exit position, the recall may stop. Remove the obstruction; then press and hold the power seat control rearward for two seconds. Try recalling the exit Heated and Ventilated Front Seats { WARNING If you cannot feel temperature change or pain to the skin, the seat heater may cause burns even at low temperatures. To reduce the risk of burns, people with such a condition should use care when using the seat heater, especially for long periods of time. Do not place anything on the seat that insulates against heat, such as a blanket, cushion, cover, or similar item. This may cause the seat heater to (Continued) Heated and Cooled Seat Buttons Shown, Heated Seat Buttons Similar If available, the buttons are on the center console. To operate, the engine must be running. I (Heated Seatback): If available, press to heat the seatback only. H (Cooled Seat): If available, press to cool the entire seat.