2014 Chevrolet Cruze Owner Manual - Page 238
2014 Chevrolet Cruze Manual
Page 238 highlights
9-46 Driving and Operating Warning (Continued) Turning the System On and Off The URPA system can be turned on and off using the infotainment system controls. See Vehicle Personalization on page 5-35. When the system is off, PARK ASSIST OFF displays on the Driver Information Center (DIC). The message disappears after a short period of time. URPA defaults to the on setting each time the vehicle is started. Turn off URPA when towing a trailer. . ice, and slush. For cleaning instructions, see Exterior Care on page 10-88. The park assist sensors are covered by frost or ice. Frost or ice can form around and behind the sensors and may not always be seen; this can occur after washing the vehicle in cold weather. The message may not clear until the frost or ice has melted. It is not available at speeds greater than 8 km/h (5 mph). To prevent injury, death, or vehicle damage, even with URPA, always check the area around the vehicle and check all mirrors before backing. How the System Works URPA comes on automatically when the shift lever is moved into R (Reverse). A single beep sounds to indicate the system is working. An obstacle detection is indicated by beeps. The interval between the beeps becomes shorter as the vehicle gets closer to the obstacle. When the distance is less than 30 cm (12 in), the beeping is a continuous beep for five seconds. When the System Does Not Seem to Work Properly The following messages may be displayed on the DIC: SERVICE PARKING ASSIST: If this message occurs, check the following conditions: . If the above conditions do not exist, take the vehicle to your dealer to repair the system. PARK ASSIST OFF: If the URPA system does not activate due to a temporary condition, the message displays on the DIC. This can occur under the following conditions: . The driver has disabled the system. The ultrasonic sensors are not clean. Keep the vehicle's rear bumper free of mud, dirt, snow,