2014 Chevrolet Cruze Owner Manual - Page 334

10-72 Vehicle Care To install a new sealant canister: 1. Align the sealant/air hose (7) with the slot in the air compressor. 2. Push the sealant canister (2) down and turn it clockwise. 3. Wrap the sealant/air hose (7) around the air compressor channel to stow it in its original location. 4. Push the air only hose (6) onto the sealant canister inlet and push the lever down. 2. Turn the left knob counterclockwise and the right knob clockwise, 90 degrees, at the same time. Then pull the access panel rearward and up to remove it. 1. Unlock the air only hose (6) from the sealant canister (2) by pulling up on the lever. 2. Pull the air only hose (6) from the sealant canister (2). 3. Unwrap the sealant/air hose (7) from the compressor (1). Storing the Tire Sealant and Compressor Kit The tire sealant and compressor kit is located in the trunk, under the load floor, behind an access panel. To remove the kit: 1. Open the trunk. See Trunk on page 2-14. 4. Turn the sealant canister (2) so the inflator filling hose is aligned with the slot in the compressor. 5. Lift the sealant canister (2) from the compressor and replace with a new sealant canister. See your dealer for more information.