2014 Chevrolet Cruze Owner Manual - Page 332
2014 Chevrolet Cruze Manual
Page 332 highlights
10-70 Vehicle Care Using the Tire Sealant and Compressor Kit without Sealant to Inflate a Tire (Not Punctured) To use the air compressor to inflate a tire with air only and not sealant: See If a Tire Goes Flat on page 10-64 for other important safety warnings. 1. Remove the tire sealant and compressor kit from its storage location. See Storing the Tire Sealant and Compressor Kit on page 10-72 or Storing the Tire Sealant and Compressor Kit (Diesel) on page 10-73. 2. Unlock the air only hose (6) from the sealant canister (2) by pulling up on the lever. 3. Pull the air only hose (6) from the sealant canister (2). 4. Remove the power plug (3) from the air compressor (1). 5. Place the kit on the ground. If a tire goes flat, avoid further tire and wheel damage by driving slowly to a level place. Turn on the hazard warning flashers. See Hazard Warning Flashers on page 6-3. Make sure the tire valve stem is positioned close to the ground so the hose will reach it. 6. Remove the tire valve stem cap by turning it counterclockwise. sealant cannot seal the tire. See Roadside Assistance Program on page 13-5. If the tire pressure has not dropped more than 68 kPa (10 psi) from the recommended inflation pressure, inflate the tire to the recommended inflation pressure. 19. Wipe off any sealant from the wheel, tire or vehicle. 20. Dispose of the used sealant canister (2) and sealant/air hose (7) assembly at a local dealer or in accordance with local state codes and practices. 21. Replace it with a new canister available from your dealer. 22. After temporarily sealing a tire using the tire sealant and compressor kit, take the vehicle to an authorized dealer within 161 km (100 mi) of driving to have the tire repaired or replaced.