2014 Chevrolet Silverado 1500 Regular Cab Owner Manual - Page 180

5-48 Instruments and Controls 2. At the same time, press and hold both the hand-held transmitter button and one of the three Universal Remote system buttons to be used to operate the garage door. Do not release either button until the indicator light goes from a slow to a rapid flash light. Then release both buttons. Some garage door openers may require substitution of Step 2 with the procedure under in "Radio Signals for Canada and Some Gate Operators" later in this section. 3. Press and hold the newly programmed Universal Remote system button for five seconds while watching the indicator light and garage door activation. . Make sure the hand-held transmitter has a new battery for quick and accurate transmission of the radio-frequency signal. programming is complete. There is no need to complete Steps 4-6. . Programming the Universal Remote System For questions or help programming the Universal Remote system, call 1-800-355-3515 or see www.homelink.com. Programming involves time-sensitive actions, and may time out causing the procedure to be repeated. To program up to three devices: 1. Hold the end of the hand-held transmitter about 3 to 8 cm (1 to 3 in) away from the Universal Remote system buttons with the indicator light in view. The hand-held transmitter was supplied by the manufacturer of the garage door opener receiver. If the indicator light does not come on or the garage door does not move, a second button press may be required. For a second time, press and hold the newly programmed button for five seconds. If the light stays on or the garage door moves, programming is complete. If the indicator light blinks rapidly for two seconds, then changes to a solid light and the garage door does not move, continue with programming Steps 4-6. . If the indicator light stays on continuously or the garage door moves when the button is pressed, then