2014 Chevrolet Silverado 1500 Regular Cab Owner Manual - Page 215

Infotainment System In general there are flexible ways to speak commands for completing the tasks. Most of them, except destination entry and voice keypad, can be completed in a single command. If the task takes more than one command to complete, the first command would be to indicate the kind of task that is to be performed. The system replies with prompts that lead through a dialog to enter the necessary information. Voice recognition can be used when the ignition is on or when Retained Accessory Power (RAP) is active. See Retained Accessory Power (RAP) on page 9-29. 1. Press g on the steering wheel control to activate voice recognition, or press the g on the infotainment touchscreen on the center stack. . 7-23 3. Wait until after the beep completes, then clearly speak one of the commands described in this section. Press g to interrupt any voice recognition system prompt. For example, if the prompt seems to be taking too long to finish, press g again and the beep should happen right away. There are two voice prompt modes supported: . If voice recognition is started from the steering wheel control, the instrument cluster displays the selections and visual dialog content. If voice recognition is started from the infotainment touchscreen on the center stack, the selections and visual dialog content are displayed on both the center stack display and the instrument cluster display. . Long verbal prompts: The longer prompts provide more information regarding the supported actions. Short prompts: The short prompts provide simple instructions about what can be stated. Using Voice Recognition Voice recognition becomes available once the system has been initialized. This begins when the ignition is turned on. Initialization may take a few moments. . 2. The audio system mutes and the system plays a prompt followed by a beep. If a command is not spoken, the voice recognition system says a help prompt.