2011 Infiniti M Owner's Manual - Page 363

Changing the dynamic driver assistance switch settings : The dynamic driver assistance switch will turn on and off the LDP, BSI and DCA systems at the same time when each system is enabled using the settings menu on the center display. 1. Push the SETTING 1 button and highlight the "Driver Assistance" key on the display using the INFINITI controller. Then push the ENTER 2 button. 2. Highlight the "Dynamic Assistance settings" key, and push the ENTER 2 button. SSD1002 SSD0996 3. Highlight the "Distance Control Assist" key, select ON (enabled) or OFF (disabled) and push the ENTER 2 button. The factory default setting is set to ON (enabled). If you set all of the systems to disable and push the dynamic driver assistance switch, the indicator of the disabled system will blink for about 4 seconds and turn off. See "LANE DEPARTURE WARNING (LDW) SYSTEM/LANE DEPARTURE PREVENTION (LDP) SYSTEM" earlier in this section and "BLIND SPOT WARNING (BSW) SYSTEM/BLIND SPOT INTERVENTION™ (BSI) SYSTEM" later in this section. Under the following conditions, the Distance Control Assist system will not operate and the Distance Control Assist (DCA) system switch indicator light will blink: ● When the drive mode select switch is turned to the SNOW mode (To use the DCA system, turn the drive mode select switch to a mode other than the SNOW mode, then turn on the dynamic driver assistance switch.) For details about the INFINITI drive mode selector, see "INFINITI DRIVE MODE SELECTOR" in the "5. Starting and driving" section. 5-68 Starting and driving