2011 Kawasaki Mule 610 4x4 XC Owners Manual - Page 125

2011 Kawasaki Mule 610 4x4 XC Manual

Page 125 highlights

STORAGE 123 STORAGE Preparation for Storage: Clean the entire vehicle thoroughly. Run the engine for about five minutes to warm the oil, shut it off and drain the engine oil. • • WARNING Gasoline is a toxic substance. Dispose of fuel properly. Contact your local authorities for approved disposal methods. WARNING Motor oil is a toxic substance. Dispose of used oil properly. Contact your local authorities for approved disposal methods or possible recycling. in fresh engine oil. • Put Empty the fuel from the fuel tank, and empty the • carburetor by loosening the drain screw at the float bowl. Catch the fuel in a suitable container. (After a period of time, fuel will break down and could clog the fuel system.) Close the drain screw when finished. NOTE żAs an alternative to draining the fuel system, a fuel stabilizer, such as STA-BIL, may be used. Follow the manufacturer's instructions for use. j WARNING Fuel stabilizers may contain poisonous substances. Heed the manufacturer's warnings for use. the spark plug and spray fogging oil, such • Remove as Kawasaki K-Kare Fogging Oil (part number K61030-002), directly into each cylinder. Turn the engine over several times with the ignition switch key to coat the cylinder walls. Install the spark plugs. WARNING Gasoline is extremely flammable and can be explosive under certain conditions and cause severe burns. Do not smoke. Turn the ignition switch "OFF". Make sure the area is well-ventilated and free from any source of flame or sparks, including any appliance with a pilot light.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139

STORAGE
123
j
STORAGE
Preparation for Storage:
Clean the entire vehicle thoroughly.
Run the engine for about five minutes to warm the
oil, shut it off and drain the engine oil.
WARNING
Motor oil is a toxic substance.
Dispose of
used oil properly. Contact your local author-
ities for approved disposal methods or pos-
sible recycling.
Put in fresh engine oil.
Empty the fuel from the fuel tank, and empty the
carburetor by loosening the drain screw at the float
bowl. Catch the fuel in a suitable container. (After
a period of time, fuel will break down and could
clog the fuel system.) Close the drain screw when
finished.
WARNING
Gasoline is extremely flammable and can
be explosive under certain conditions and
cause severe burns. Do not smoke. Turn the
ignition switch “OFF”.
Make sure the area
is well-ventilated and free from any source
of flame or sparks, including any appliance
with a pilot light.
WARNING
Gasoline is a toxic substance.
Dispose of
fuel properly. Contact your local authorities
for approved disposal methods.
NOTE
°
As an alternative to draining the fuel system, a fuel
stabilizer, such as STA-BIL, may be used. Follow
the manufacturer’s instructions for use.
WARNING
Fuel stabilizers may contain poisonous sub-
stances. Heed the manufacturer’s warnings
for use.
Remove the spark plug and spray fogging oil, such
as Kawasaki K-Kare Fogging Oil (part number
K61030–002), directly into each cylinder. Turn the
engine over several times with the ignition switch
key to coat the cylinder walls.
Install the spark
plugs.