2006 Mazda MAZDA6 Owner's Manual - Page 182
2006 Mazda MAZDA6 Manual
Page 182 highlights
Mazda6_8U66-EA-05F_Edition2 Page182 Tuesday, July 26 2005 11:25 AM Black plate (182,1) Driving Your Mazda Switches and Controls NOTE WARNING Safety Stop and Reverse Feature: Using the HomeLink system with any garage door opener that lacks the safety stop and reverse feature as required by federal safety standards is dangerous. (This includes garage doors manufactured before April 1, 1982.) Using these garage door openers can increase the risk of serious injury or death. For further information, contact HomeLink at 1-800-355-3515 or www.homelink.com or your Authorized Mazda Dealer. Safety While Programming or Operating HomeLink System: Programming or operating the HomeLink system without verifying the safety of areas surrounding garage doors and gates is dangerous and could result in an unexpected accident and serious injury if someone were to be hit. Always check the areas surrounding garage doors and gates for people or obstructions before programming or during operation of the HomeLink system. FCC ID: NZLOBIHL3 CANADA: 4112A-OBIHL3 This device complies with FCC rules part 15. Operation is subject to the following conditions: 1- This device may not cause any harmful interference and 2- This device must accept any interference that may be received including interference that may cause undesired operation. NOTE The programming will not be erased even if the battery is disconnected. qPre-programming the HomeLink System NOTE It is recommended that a new battery be placed in the hand-held transmitter of the device being programmed to HomeLink for quicker training and accurate transmission of the radiofrequency signal. l CAUTION HomeLink has been tested and complies with FCC and Industry Canada rules. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the device. Verify that there is a remote control transmitter available for the device you would like to program. Disconnect the power to the device. l 5-48 Form No.8U66-EA-05F