2006 Mazda MAZDA6 Owner's Manual - Page 292

Mazda6_8U66-EA-05F_Edition2 Page292 Tuesday, July 26 2005 11:27 AM Black plate (292,1) Maintenance and Care Owner Maintenance If new fluid is required frequently, consult an Authorized Mazda Dealer. 3.0-liter engine Inspect the fluid level at each engine oil change. Add fluid if necessary; it does not require periodic changing. Automatic Transaxle Fluid (ATF) qInspecting Automatic Transaxle Fluid Level The automatic transaxle fluid level should be inspected regularly. Measure it as described below. 2.3-liter engine Loosen High OK Low Tighten CAUTION l The level must be kept between the H and L marks. Visually examine the lines and hoses for leaks and damage. 1. Park on a level surface, well off the right-of-way, and set the parking brake firmly. 2. Turn off the engine and allow it to cool. 3. Remove the filler cap and attached dipstick. 4. Wipe them clean and put them back. 5. Remove again and inspect the level. 6. It must be between H and L. Add fluid if necessary. Don't overfill. If new fluid is required frequently, consult an Authorized Mazda Dealer. l l Always check the automatic transaxle fluid level according to the following procedure. If the procedure is not done correctly, the automatic transaxle fluid level cannot be measured accurately which could lead to automatic transaxle damage. A low fluid level can cause transaxle slippage. Overfilling can cause foaming, loss of fluid, and transaxle malfunction. Use only the specified fluid. A nonspecified fluid could result in transaxle malfunction and failure. 1. Park on a level surface and set the parking brake firmly. 2. Make sure there is no ATF leakage from the ATF hose or the housing. 3. Shift the shift lever to the park position (P), start the engine and warm it up. 8-26 Form No.8U66-EA-05F