2006 Mazda MAZDA6 Owner's Manual - Page 184
2006 Mazda MAZDA6 Manual
Page 184 highlights
Mazda6_8U66-EA-05F_Edition2 Page184 Tuesday, July 26 2005 11:25 AM Black plate (184,1) Driving Your Mazda Switches and Controls 7. Firmly press and release the "learn" or "smart" button. (The name and color of the button may vary by manufacturer.) NOTE qGate operator/Canadian Programming Canadian radio-frequency laws require transmitter signals to "time-out" (or quit) after several seconds of transmission ― which may not be long enough for HomeLink to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to "time-out" in the same manner. If you live in Canada or you are having difficulties programming a gate operator by using the "Programming" procedures (regardless of where you live), replace "Programming HomeLink" step 3 with the following: NOTE There are 30 seconds in which to initiate step 8. 8. Return to the vehicle and firmly press, hold for two seconds and release the programmed HomeLink button. Repeat the "press/hold/release" sequence a second time, and, depending on the brand of the garage door opener (or other rolling code equipped device), repeat this sequence a third time to complete the programming process. HomeLink should now activate your rolling code equipped device. NOTE To program the remaining two HomeLink buttons, begin with "Programming" ― step 2. Do not repeat step 1. For questions or comments, please contact HomeLink at www.homelink.com or 1800-355-3515. If programming a garage door opener or gate operator, it is advised to unplug the device during the "cycling" process to prevent possible overheating. Continue to press and hold the HomeLink button while you press and release ― every two seconds ("cycle") your handheld transmitter until the frequency signal has successfully been accepted by HomeLink. (The indicator light will flash slowly and then rapidly.) Proceed with "Programming" step 4 to complete. qOperating the HomeLink System Press the programmed HomeLink button to operate a programmed device. The code will continue being transmitted for a maximum of 20 seconds. 5-50 Form No.8U66-EA-05F