2011 Mercedes SL-Class Owner's Manual - Page 174

172 Useful features Stolen Vehicle Recovery Services In the event your vehicle was stolen: X Controls in detail Report the incident to the police. The police will issue a numbered incident report. X Pass this number on to the Customer Assistance Center along with your password. The Customer Assistance Center will then attempt to covertly contact the vehicle's Tele Aid system. Once the vehicle is located, the Customer Assistance Center will contact the local law enforcement and you. The vehicle's location will only be provided to law enforcement. federal safety standards (this includes any garage door opener model manufactured before April 1, 1982). A garage door that cannot detect an object - signaling the door to stop and reverse - does not meet current U.S. federal safety standards. When programming a garage door opener, park vehicle outside the garage. Do not run the engine while programming the integrated remote control. Inhalation of exhaust gas is hazardous to your health. All exhaust gas contains carbon monoxide (CO), and inhaling it can cause unconsciousness and possible death. i If the anti-theft alarm or the tow-away alarm stays on for more than 30 seconds, a call to the Customer Assistance Center is initiated automatically by the Tele Aid system provided Tele Aid service was subscribed to and properly activated, and that necessary cellular service and GPS coverage are available. See "Anti-theft alarm system" (Y page 63) and "Tow-away alarm" (Y page 64). Garage door opener The integrated remote control can operate up to three separately controlled devices compatible with HomeLink® or some other systems. Interior rear view mirror with integrated remote control Hand-held remote control A is not part of the vehicle equipment. Programming the integrated remote control X X G Warning! Before programming the integrated remote control to a garage door opener or gate operator, make sure people and objects are out of the way of the device to prevent potential harm or damage. When programming a garage door opener, the door moves up or down. When programming a gate operator, the gate opens or closes. Do not use the integrated remote control with any garage door opener that lacks safety stop and reverse features as required by U.S. Step 1: Switch on the ignition. Step 2: If you have previously programmed a signal transmitter button and wish to retain its programming, proceed to step 3. If you are programming the integrated remote control for the first time, press and hold the two outer signal transmitter buttons ; and ? and release them when indicator lamp : begins to flash after approximately 20 seconds. or X