2000 Nissan Quest Owner's Manual - Page 120
2000 Nissan Quest Manual
Page 120 highlights
door, does not meet current federal safety standards. Using a garage door opener without these features increases the risk of serious injury or death. Your vehicle's engine should be turned off while programming your transmitter. The Integrated HomeLink Universal Transceiver may not work with older garage door openers that do not meet current Federal Consumer Safety Standards. 1. Test the Integrated HomeLink Universal Transceiver by pressing any button. The red indicator light should come on. If you have previously programmed a button proceed to step 3. 2. Clear all channels on the Integrated HomeLink Universal Transceiver by holding down both outside buttons (#1 & #3) until the red light begins to flash rapidly (approximately 20 seconds). Then release both buttons. 3. Select which of the three Integrated HomeLink Universal Transceiver buttons you want to program. 4. Hold your hand-held transmitter against the bottom surface of the Integrated HomeLink Universal Transceiver so that you can still see the red indicator light. Instruments and controls 2-33 AIC1069 PROGRAMMING HomeLink WARNING During the programming procedure your garage door or security gate will open and close (if the transmitter is within range). Make sure that people or objects are clear of the garage door, gate, etc. that you are programming.