2000 Nissan Quest Owner's Manual - Page 121
2000 Nissan Quest Manual
Page 121 highlights
5. Press the desired button until the red indicator light flashes slowly. Do not release the button. Continue holding and press the hand-held transmitter button through step 6. 6. Hold down both buttons until the red indicator light on the Integrated HomeLink Universal Transceiver flashes rapidly (This may take 1 to 90 seconds). Then release both buttons. The rapid flashing means that the transceiver has been successfully programmed to match your hand-held transmitter. You can now use the Integrated HomeLink Universal Transceiver instead of your hand-held transmitter. HomeLink Universal Transceiver should blink rapidly indicating a successful programming procedure. If it returns to the slow blink of program mode, continue to periodically reactivate your hand-held transmitter until a successful programming procedure is indicated by the rapidly flashing indicator light. ● Hold your hand-held transmitter against the bottom surface of the Integrated HomeLink Universal Transceiver so that you can still see the red indicator light. ● Hold buttons for duration of the programming without interruption. ● Rotate your hand-held transmitter endover-end and program again. For best results, place the end opposite the battery compartment against the Integrated HomeLink Universal Transceiver when programming. OPERATING THE INTEGRATED HomeLink UNIVERSAL TRANSCEIVER To operate, simply press the appropriate button on the Integrated HomeLink Universal Transceiver. The red indicator light illuminates while the signal is being transmitted. The effective transmission range of the Integrated HomeLink Universal Transceiver may differ from your hand-held transmitter. PROGRAMMING Homelink FOR CANADIAN CUSTOMERS Prior to 1992, D.O.C. regulations required many hand-held transmitters to stop transmitting after one or two seconds, even though you continue to hold down the button. If you think you have one of these hand-held transmitters, you should press and re-press the transmitter button every 2 seconds without ever releasing the Integrated HomeLink Universal Transceiver button. The indicator light on the Integrated PROGRAMMING PROBLEM DIAGNOSIS Be sure to keep your original hand-held transmitter for possible reprogramming if necessary. ● Make sure batteries in the hand-held transmitter are fully charged. 2-34 Instruments and controls