2000 Nissan Quest Owner's Manual - Page 159

Clock operation The clock is on in the display regardless of what mode, media, or function the radio is in as long as the ignition is in ACC or ON. Clock set Press the RDS/CLK button until SELECT HOURS is displayed then use the SEL buttons to change the hour, press the RDS/CLK button again until SELECT MINS is displayed then use the SEL buttons to change the minutes. The display will return to clock priority mode in 10 seconds or press the RDS/CLK button to return to the clock display. Selecting the desired band Push the AM or FM buttons to change to AM or FM band reception. The FM stereo indicator, ST illuminates during FM stereo reception. When the stereo broadcast signal is weak, the radio automatically changes from stereo to monaural reception. TUNE buttons WARNING The radio should not be tuned while driving so full attention may be given to vehicle operation. Use the or buttons for manual tuning. To move quickly through the channels, hold either of the tune buttons down for more than 0.5 seconds. AUTO SET Press the AUTO button while listening to the radio to activate the auto set feature. When AUTO is depressed for less than 5 seconds, the display window momentarily indicates AUTO ON, and the radio seeks the first six strong stations for the respective band. The first six strong stations are then stored in order in memory buttons one through six. Only stations in the selected band are set, and the station seek begins from the last frequency stored in memory button six. If AM, FM, SCAN, TUNE, SEEK, AUTO or a memory button is pushed while auto set is operating, auto set is canceled and AUTO OFF shows in the display window. AUTO LOAD Press the AUTO button for longer than 5 seconds while listening to the radio to activate the auto load feature. When AUTO is depressed for longer than 5 seconds, the display window momentarily indicates AUTO LOAD, and the radio seeks the first six strong stations for every band. The first six strong stations are then stored in order in memory buttons one through six for each band (AM, FM1, and FM2). SEEK tuning Push the SEEK or buttons to find the next broadcast station. Pushing the SEEKS up and button SEEKS down. Pushing the button again continues the SEEK function. Once the highest broadcast station is reached, the radio continues in the SEEK mode at the lowest station. Once the lowest broadcast station is reached, the radio continues in the SEEK mode at the highest station. SCAN tuning Push the SCAN tuning button, SCAN illuminates in the display. SCAN tuning begins FM-AM radio operation MUTE button Push the MUTE button to mute out the radio. 4-18 Heater, air conditioner and audio systems