2010 Nissan Altima Owner's Manual - Page 214

iPod MENU button This button can only be used for iPod operations. See "iPod player operation without Navigation System" later in this section for details about the function of this button. When the AUX button is pressed while the ignition switch is in the ACC or ON position, the radio will come on at the station last played. The last station played will also come on when the VOL/ON-OFF control knob is pressed to turn the radio on. *When the AUX button is pressed, the satellite radio mode will be skipped unless an optional satellite receiver and antenna are installed and an XM satellite radio service subscription is active. Satellite radio is not available in Alaska, Hawaii and Guam. If a compact disc is playing when the AUX button is pressed, the compact disc will automatically be turned off and the last radio station played will come on. SCROLL/TUNE knob (Tuning): Turn the SCROLL/TUNE knob to the left or right for manual tuning. SEEK tuning: Press the SEEK/CATEGORY button or to tune from low to high or high to low frequencies and to stop at the next broadcasting station. SCAN tuning: Press the SCAN button to stop at each broadcasting station for 5 seconds. SCAN will appear on the screen while the radio is scan tuning. Pressing the button again during this 5 second period will stop SCAN tuning and the radio will remain tuned to that station. If the SCAN button is not pressed within 5 seconds, SCAN tuning moves to the next station. 1 to 6 Station memory operations: Twelve stations can be set for the FM band (6 for FM1, 6 for FM2) and six stations can be set for the AM band. 1. Choose the radio band AM, FM1 or FM2 using the AM·FM select button. 2. Tune to the desired station using manual, SEEK or SCAN tuning. Press and hold any of the desired station memory buttons (1 - 6) until a beep sound is heard. 3. The channel indicator will then come on and the sound will resume. Programming is now complete. 4. Other buttons can be set in the same manner. FM/AM/SAT radio operation AM·FM button: Press the AM·FM button to change the band as follows: AM → FM1 → FM2 → AM If another audio source is playing when the AM·FM button is pressed, the audio source playing will automatically be turned off and the last radio station played will begin playing. The FM stereo indicator (STEREO) is shown on the screen during FM stereo reception. When the stereo broadcast signal is weak, the radio automatically changes from stereo to monaural reception. SAT band select: Pressing the AUX button will change the band as follows: AUX → XM1* → XM2* → AUX (satellite, if so equipped) Monitor, climate, audio, phone and voice recognition systems 4-51