2010 Nissan Altima Owner's Manual - Page 52

7. Check to make sure that the child restraint is properly secured prior to each use. If the seat belt is not locked, repeat steps 1 through 6. After the child restraint is removed and the seat belt fully retracted, the ALR mode (child restraint mode) is canceled. WRS0763 LRS0824 Rear-facing - step 6 6. After attaching the child restraint, test it before you place the child in it. Push it from side to side while holding the child restraint near the seat belt path. The child restraint should not move more than 1 inch (25 mm), from side to side. Try to tug it forward and check to see if the belt holds the restraint in place. If the restraint is not secure, tighten the seat belt as necessary, or put the restraint in another seat and test it again. You may need to try a different child restraint. Not all child restraints fit in all types of vehicles. (if so equipped) FORWARD-FACING CHILD RESTRAINT INSTALLATION USING LATCH Refer to all Warnings and Cautions in the "Child Safety" and "Child Restraint" sections before installing a child restraint. Follow these steps to install a forward-facing child restraint using the LATCH system: 1. If the rear seat cushion has a flap 1 , pull the flap down to allow access to the anchors 2 . 2. Position the child restraint on the seat. Always follow the child restraint manufacturer's instructions. Safety-Seats, seat belts and supplemental restraint system 1-33