2010 Nissan Altima Owner's Manual - Page 261

(Speak Digits) B When prompted by the system, say the number you wish to call. Refer to "How to say numbers" and "Making a call by entering a phone number" in this section for more details. "Special Number" C For dialing more than 10 digits or any special characters, say "Special Number". When the system acknowledges the command, the system will prompt you to speak the number. "Redial" D Use the Redial command to call the last number that was dialed. The system acknowledges the command, repeats the number and begins dialing. If a redial number does not exist, the system announces, "There is no number to redial" and ends the VR session. "Call back" E Use the Call Back command to dial the number of the last incoming call within the vehicle. The system acknowledges the command, repeats the number and begins dialing. If a call back number does not exist, the system announces, "There is no number to call back" and ends the VR session. During a call During a call there are several command options button on the steering available. Press the wheel to mute the receiving voice and enter commands. ● "Help" - The system announces the available commands. ● "Go back/Correction" - The system announces "Go back," ends the VR session and returns to the call. ● "Cancel/Quit" - The system announces "Cancel," ends the VR session and returns to the call. ● "Send/Enter/Call/Dial" - Use the Send command to enter numbers, "*" or "#" during a call. For example, if you were directed to dial an extension by an automated system: Say: "Send one two three four." The system acknowledges the command and sends the tones associated with the numbers. The system then ends the VR session and returns to the call. Say "star" for "*", Say "pound" for "#". ● "Transfer call" - Use the Transfer Call command to transfer the call from the Bluetooth Hands-Free Phone System to the cellular phone when privacy is desired. The system announces, "Transfer call. Call transferred to privacy mode." The system then ends the VR session. To reconnect the call from the cellular phone to the Bluetooth Hands-Free System, button. press the ● "Mute" - Use the Mute command to mute your voice so the other party cannot hear it. Use the mute command again to unmute your voice. NOTE: If a call is ended or the cellular phone network connection is lost while the Mute feature is on, the Mute feature will be reset to "off" for the next call so the other party can hear your voice. 4-98 Monitor, climate, audio, phone and voice recognition systems