1998 Oldsmobile Silhouette Owner's Manual - Page 121

Resetting thePower Sliding Door The power sliding doormay operate incorrectly or not at all because of the following conditions: 6. Disable the power sliding door override feature. 7. Push either of the power door buttons to open the power sliding door. A low voltage or dead battery, Disconnecting the battery or If the IGN 1, B/U LAMP, RADIO or PWR SEATPSD fuse isremoved or blown. See "Fuse Panel" in the Index for more information about your fuse panel. If any of these conditionsoccur, the power sliding door will need to be reset. To do this, follow the directions listed here.It will be easierif you read through them once before beginning this procedure. 1. Check to be sure the power sliding door isunlocked and securely closed. 8. Wait five seconds and close the door by pushing either power door button. 9. Wait five seconds and repeat Steps 7 and 8. If the door does not rest in the fully open position after repeating Step 7, repeat Steps7 and 8 again. If the door still does not operate correctly, see your retailer for service. Sliding Door Security Lock Your vehicle is equipped with a slidingdoor security lock that helps prevent young children or other passengers fromopening the sliding door by using the inside door handle. This lock on both doors if your is vehicle has the dual slidingdoors. If you have the optional power sliding door, you can override the security lock by pressing either power door switch when the power sliding door override featureis disabled. See"Power Sliding Door" earlier in the section. 2. Turn the ignition switch to OFF. 3. Enable the power sliding door override feature. 4. Remove the RADIO fuse from theunderhood fuse 30 and relay center. Leave it out for seconds. 5. Reinstall the fuse and wait 10 seconds. 2-19